0.00
#...
·
|
---|
Hello. I am at a new setup (New Computer) and have installed ASCOM ver.6.6 and all the drivers for mounts camera etc... I now need in my small setup. But when I open the dialog box and want to activate my mount (Skywatcher EQ5) I get this notification. Does anyone have a suggestion for a solution. |
0.00
#...
·
·
1
like
|
---|
Try to install Ascom drivers after all the devices connected |
0.00
#...
·
|
---|
Hello Again. I followed Nicola's suggestion and the dialog box came up and got the coordinates entered and everything was fine but I wanted to double check and restarted the computer, wanted to try again and then I was back where I was from the start, (the same error message) I use SGL for imaging but have been thinking for a while about trying N.I.N.A for imaging and here I get this message about my issue I have searched for time configuration but can't immediately find out about this. So I'm asking if there are any of you out there who have encountered this problem like I have?? My new computer is Mini PC Intel NUC11TNKi5 and has Windows 11 installed. |